Fitting Fundos

Click on the links below to see full fitting instructions for:

Walk In Fundos - Concrete Floors Walk In Fundos - Wooden Floors

Round Trollo Kits Spiral Nautilo Kits Fundo Easy Set Kits

Walk-in Fundos for concrete floors

Step 1

Insert the '0' ring seal in the groove provided in the plastic frame prefabricated into the Fundo base.

Insert the main sealing collar from beneath the Fundo base unit, making sure that the Solid rubber section of the seal faces the metal plate on the Fundo base.

At the same time insert the screw threaded clamping collar from the upper side. With the aid of the cap tool tighten the two parts together.

Step 2

Connect the coupling spigot of the drain to the existing drainage pipework. Site the drain unit in the exact location for both height and position for later connection to the Fundo base element. Check all joints are tightened.

Step 3

Fill the void around the drain and pipework with a suitable mortar. Compress and level out the whole area to the top of the drain body.

Step 4

Fully coat the underside of the Fundo base unit with cement based adhesive to 4-5mm thickness.

Step 5

Accurately position the Fundo base over the drain outlet and carefully push the main sealing collar into the drain body. Level out Fundo as required.

Step 6

Build up the rest of the floor area with 40mm wedi Tilebacker Board if required.

Step 7

Seal all edges of Fundo with wedi waterproof sealing tape bedded into cement based tile adhesive.

Step 8

Place the grid support frame in position. The height may be adjusted by cutting the drain extension collar to correspond with the relevant tile thickness being fixed.

Step 9

Place the grid support frame in position. The height may be adjusted by cutting the drain extension collar to correspond with the relevant tile thickness being fixed.